Easy pre-filght brake fluid reservoir

[orchardair]

I wanted a brake fluid reservoir I could easily see the fluid level in.

I had a couple of old air filters I got years ago from Harbor freight for my air compressor. HF has since changed their design, but you can still get similar ones off of ebay:

filter.JPG (19.24 KiB) Viewed 1042 times

I only used the bottom clear bowl. The trick is to get the ones with a 1/8" NPT fitting on the bottom. You can unscrew the pressure release valve at the bottom out.

I then cut the top 1" of the bowl off, to get rid of the odd size thread.

Ordered a 1/8" thick Lexan sheet, cut to size and drilled and tapped for a plug that is also a breather vent. Drilling with a step-bit was easy.

process.JPG (39.18 KiB) Viewed 1042 times

super-glue, sand to look nice.

done.JPG (47.23 KiB) Viewed 1042 times

And here it is with the master cylinder

master.JPG (107.7 KiB) Viewed 1042 times

I will test with brake fluid before I commit to this, to make sure the plastics are good with the fluid, but I am optimistic.

[jwhanson]

What brand of master cylinder is that?
John Hanson

[orchardair]

What brand of master cylinder is that?
John Hanson

Matco:
http://www.matcomfg.com/MASTERCYLINDERS ... 265-5.html