Regarding the part that clamps the tail spring right under the vertical post of the vertical stabilizer:
The plans don't specify the thickness of the material. Am I correct to say that the part welded to the fuselage is 0.125" thick, while the "U" shaped bracket with the two 5/16" tubing on the sides is made out of 0.090"?
Sheet 13 - Tailwheel spring mount
-
orchardair
- Posts: 215
- Joined: Thu Apr 08, 2010 4:56 pm
Sheet 13 - Tailwheel spring mount
Hatz Classic plans# 136
-
RSouthard
- Posts: 48
- Joined: Tue Mar 16, 2010 9:40 pm
- Location: Seaford Delaware
Re: Sheet 13 - Tailwheel spring mount
I used .0125 for both parts.
- Tail wheel spring mount & bracket.JPG (1.6 MiB) Viewed 2274 times
-
jwhanson
- Posts: 96
- Joined: Tue Mar 16, 2010 11:55 pm
Re: Sheet 13 - Tailwheel spring mount
Hi Ron,
I used .090 for the piece that is welded to the tail post and .063 for the U shape bracket. No problems so far.
John Hanson
I used .090 for the piece that is welded to the tail post and .063 for the U shape bracket. No problems so far.
John Hanson